Drag to rotate
Mirror Extension 190 mm
for Jeep Gladiator with camper cabin
With a wide cabin on the bed, the stock mirror mostly shows one thing: the cabin wall. The extension is mounted between the door and the original mirror bracket and moves the complete mirror 190 mm further out. Your view to the rear is clear again – and the original mirror stays exactly as it is.
- Offset
- 190 mm outwards
- Mounting
- between door and original mirror bracket
- Material
- ASA, black – UV and weather resistant
- Manufacturing
- 3D printed, paintable
- Version
- left / right
- Scope of delivery
- extension only, no mounting hardware
Price on request
Where does the extension go?
The extension goes between the door and the original mirror bracket. The complete original mirror is reused – it simply sits 190 mm further out.
Right here – between door and mirror bracket
Installation in three steps
- Remove the mirror
Detach the original mirror bracket from the door.
- Attach mirror to extension
Fasten the bracket to the extension using one of the original bolts.
- Mount to the door
Fit the extension and mirror as one unit to the original mounting points on the door – using two M8 × 230 mm threaded rods with nuts and another original bolt.
Not included: 2 M8 × 230 mm threaded rods with nuts. All other bolts are reused from the original mirror.
About manufacturing: The extension is 3D printed. Due to the process, the surface may show minor cosmetic irregularities such as fine layer lines. If you prefer a custom look, the part can be painted after the usual surface preparation – in your vehicle colour, for example.
